부품 정보
Cable assembly tlc 50 ohm
TXT
묘사:
Electrical Ribbon Cable Assembly
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
Missile, patriot
MRC:
The center to center distance between the terminal holes.AGTK
Center To Center Distance Between Terminal Holes:
0.100 inches
MRC:
Indicates the type of facility provided on the device for attaching to another item.AKRZ
Termination Type:
Connector plug both ends all conductors
MRC:
The number of electrical conductors included on the item.AMQN
Conductor Quantity:
25
MRC:
The fabricated form of the conductor.CXCW
Conductor Form:
Solid all conductors
MRC:
The designation used to describe the round stranded or round solid conductor size.CXDC
Round Conductor Size:
30 awg all conductors
MRC:
The arrangement and number of arrangements of the conductors.CXDQ
Conductor Arrangement And Quantity:
25 molded
MRC:
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.FEAT
Special Features:
Connector housing contains standard pressure copper alloy recept contacts plated with .000030 inch min thick gold over .000050 inch min thick nickle in mating area. P2 connector must mate and match to amp part no. 1-102158-0. P1 and p2 connector housings shall be thermoplastic. The housing is a 50 position header. Pull tabs shall be provided. The cable shall be 50 ohm transmission line cable with 25 signal conds 30 awg silver plated copper, 50 ground conds 32 awg silver plated copper impedance 50 ohm +- 5 ohm. Cap 28 pico-farads per foot . Propagation delay of 14 nanoseconds per foot. Pin 1 is to be clearly identified on p1 and p2. Resistance of the cable assembly shall be less than .21 ohms for signal conds and less than .18 ohms for ground conds. Cable assemblies must be able to withstand 300 vdc between any adjacent signal and/or ground paths. Impedance of cable assembly shall be 50 +- 5 ohms.
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Copper core conductor all conductors
MRC:
An indication of the precious material and its location in the item.PMLC
Precious Material And Location:
Plating on connector ends 0.000030 inches thick gold and plating on all wires silver
MRC:
Identification of the precious material contained in the item.PRMT
Precious Material:
Gold and silver
MRC:
The metallic,nonmetallic,and/or chemical properties with which the item is plated,dipped,and/or coated.the treatment is designed to protect the surface(s) and cannot be wiped off.SFTT
Surface Treatment:
Silver core conductor all conductors
