TXT
묘사:
Assembled Washer Screw
MRC:
The direction of the thread when viewed axially. a right-hand thread winds in a clockwise direction while a left-hand thread winds in a counterclockwise direction.AAJF
Thread Direction:
Right-hand
MRC:
The dimension,measured along a line parallel to the longitudinal axis,from the largest bearing surface of the fastener head to the extreme opposite end,or as specifically designated for other type fasteners.AASB
Fastener Length:
Between 2.270 inches and 2.330 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the head.AASK
Head Style:
Hexagon extended washer
MRC:
A measurement from the bottom to the top of the head,in distinction from depth.AASU
Head Height:
0.950 inches
Width Between Flats:
Between 1.469 inches and 1.500 inches
Extended Washer Diameter:
1.920 inches
Extended Washer Thickness:
0.160 inches
MRC:
The number of washers included on the item.AAVW
Washer Quantity:
1
MRC:
The minimum load,applied perpendicularly to the longitudinal axis of an item,at which point the item will fracture when subjected to the standard single shear test method.AAWU
Single Shear Strength:
15000 pounds per square inch
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the internal drive.ABQZ
Internal Drive Style:
W/o internal drive
MRC:
The maximum rated load in tension applied in a longitudinal direction,per unit of cross-sectional area,that the material can withstand without rupture.CQBC
Min. Tensile Strength (psi):
150000 pounds per square inch
MRC:
A numeric value that reflects the hardness of an item when used in conjunction with a hardness rating scale.CQFM
Hardness Rating:
28.0 rockwell c and 55.0 rockwell c
MRC:
The stress at which a material exhibits a specified limiting deviation from the proportionality of stress or strain.CQHQ
Minimum Yield Strength:
130000 pounds per square inch
Primary Washer Outside Diameter:
1.920 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the primary washer.CTHW
Primary Washer Style:
Flat
Primary Washer Material Thickness:
0.160 inches
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel comp 429
