부품 정보
Id below 0.750 in. Depth may taper to 0.004 in. Less than specified id
MRC:
The length of a straight line which passes through the center of a hole,and terminates at the circumference.AAUB
Hole Diameter:
0.0620 inches first
MRC:
A measurement of the longest dimension of the slot,in distinction from width.ABGD
Slot Length:
0.1300 inches first
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
Between 1.1550 inches and 1.1600 inches
MRC:
The length of a straight line which passes through the center of the body,and terminates at the outside circumference.ADAR
Body Outside Diameter:
Between 0.3580 inches and 0.3590 inches
MRC:
The length of a straight line which passes through the center of a body,and terminates at the inside circumference.ADAS
Body Inside Diameter:
Between 0.2806 inches and 0.2813 inches
Left Internal Flange Hole Diameter:
0.0625 inches
Left Internal Flange Width:
0.0500 inches
MRC:
The physical configuration of the corner.BZLX
Corner Shape:
Chamfered outside left corner
MRC:
The physical configuration of the corner.BZLX
Corner Shape:
Square inside right corner
MRC:
The physical configuration of the corner.BZLX
Corner Shape:
Square inside left corner
MRC:
The physical configuration of the corner.BZLX
Corner Shape:
Square outside right corner
MRC:
Indicates the type and number of features used for the introduction of a lubricant or an antirotational device.CTJM
Antirotation/lubrication Type And Quantity:
1 hole and 1 slot
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel comp e52100
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
17c-1 solid, plain, no outside flanges, internal flange one end
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Solid, plain, no outside flanges, internal flange one end
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
81349-mil-i-6868 specification (includes engineering type bulletins, brochures, etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "", etc.).
