부품 정보
Fitting, union, dynamic beam seal, bulkhead, 5000 psi
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
V-22 osprey
MRC:
The number of threads on the item per linear inch measured on a line parallel to the thread axis.CMLP
Thready Qty Per Inch (tpi):
16 2nd end
MRC:
The maximum pressure at which the item is rated for operation.CQGM
Maximum Operating Pressure:
5000.0 pounds per square inch single response
MRC:
A designation that is used for the purpose of general identification of the thread.CQJX
Thread Size:
1.000 inches 2nd end
MRC:
The shortest nominal straight line between flats,perpendicular to the height of an item.CWCN
Width Across Flats:
1.250 inches 2nd end
MRC:
The nominal length of a straight line which passes through the center of the accommodated hose,and terminates at the inside circumference.CWDW
Inside Diameter Hose Accommodated:
0.750 inches 1st end
MRC:
The nominal dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.CWFR
Nominallength:
1.774 inches
MRC:
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.FEAT
Special Features:
Material: 6al-4v titanium per ams 4965, finish: solid lube per mil-l-46010, type 1, on concave sealing surfaces only
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Titanium
MRC:
The metallic,nonmetallic,and/or chemical properties with which the item is plated,dipped,and/or coated.the treatment is designed to protect the surface(s) and cannot be wiped off.SFTT
Surface Treatment:
Lubricant
MRC:
Test conditions and ratings,or environmental and performance requirements that are different,more critical,or more specific than those specified in a governing test data document.SPCL
Special Test Features:
Tube size: 0.750", length: 1.774", length from 1st end to nut: 0.990", length from 2nd end to nut: 0.412", width between flats / hex head: 1.250", thread per mil-s-8879: 1.0000-16 unj-3a, weight: .145lbs
MRC:
Characteristics or qualities of an item,not covered in any other requirement,which are considered essential information for one or more functions excluding nsn assignment.SUPP
Supplementary Features:
Operating pressure: 5, 000psi, proof pressure: 10, 000psi, burst pressure: 20, 000psi
MRC:
A designation distinguishing one group of thread diameter-pitch combinations from another by the number of threads per measurement scale for a specific diameter.THSD
Thread Series Designator:
Unj 2nd end
