부품 정보
Fastener, blind, high strength, pull type, positive mechanical lock, protruding head, alloy steel, 112 k.S.I. Fsu
MRC:
The dimension,measured along a line parallel to the longitudinal axis,from the largest bearing surface of the fastener head to the extreme opposite end,or as specifically designated for other type fasteners.AASB
Fastener Length:
0.531 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the head.AASK
Head Style:
Flat fillister w/protruding stud
MRC:
A measurement from the bottom to the top of the head,in distinction from depth.AASU
Head Height:
Between 0.130 inches and 0.140 inches
MRC:
The length of a straight line which passes through the center of the body of the shank and terminates at the circumference.AAZE
Shank Diameter:
Between 0.256 inches and 0.260 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the shank.AAZF
Shank Style:
Self-plugging mechanically locked stem
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
Structural, vertical; fitting, structural
MRC:
A measurement of the longest dimension of the grip,in distinction from width.ANEE
Grip Length:
1.000 inches
MRC:
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.FEAT
Special Features:
Sleeve and serated pin- alloy steel per astm-a-331. Mechanical lock: carbon steel or alloy steel conforming to the chemical composition of 1010, 1020, 1144, 4037, or 4130 of the federal standard 66 or a286 cres conforming to the chemical limits of ams 5737, or type 316 cres conforming to the chemical requirements of ams5690. Ms90354 has been replaced by nasm90354 dated june 29, 2000
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel sleeve
