TXT
묘사:
Engine Accessory Generator
MRC:
The length of a straight line which passes through the center of the smallest cross section of a spline,and terminates at the circumference.AAUH
Spline Minor Diameter:
Between 0.655 inches and 0.665 inches
MRC:
The length of a straight line which passes through the center of the largest cross section of a spline,and terminates at the circumference.AAUJ
Spline Major Diameter:
Between 0.848 inches and 0.850 inches
Spline Width:
Between 0.204 inches and 0.207 inches
MRC:
The distance,measured along a straight line perpendicular to the longitudinal axis of the slot,from one edge to the other.ABGC
Slot Width:
Between 0.400 inches and 0.430 inches
MRC:
A measurement of the longest dimension of the slot,in distinction from width.ABGD
Slot Length:
Between 1.1985 inches and 1.2255 inches
MRC:
The number of splines on or in the item.ABSA
Spline Quantity:
6
Mounting Hole Circle Radius:
2.500 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the mounting.ADER
Mounting Style:
Round flange w/slots evenly spaced
MRC:
An indication of whether or not an item is capable of operation while submerged.AHZV
Submersibility:
Nonsubmersible
MRC:
The maximum altitude at which the item is rated to function.AKAE
Maximum Operating Altitude Rating:
20000.0 feet
MRC:
The direction of rotation of a rotating shaft as viewed from the drive end.AKCT
Shaft Rotation Direction:
Counterclockwise
MRC:
The number of slots in the item.ATPP
Slot Quantity:
6
MRC:
A measurement of the longest dimension of a spline,in distinction from width.AXFH
Spline Length:
Between 1.450 inches and 1.460 inches
MRC:
Indicates the type of ground polarity utilized.AXHX
Ground Polarity Type:
Negative
MRC:
The minimum speed the armature can revolve and maintain full current output,expressed in revolutions per minute.BCGD
Armature Minimum Speed In Rpm At Full Current Output:
2650
MRC:
The maximum amount of output current for which the item is rated,expressed in amperes.BCGF
Maximum Output Current Rating In Amps:
100.0
MRC:
The cut-in speed necessary to maintain a minimum current flow,expressed in revolutions per minute.BCGG
Minimum Current Cut-in Speed In Rpm:
2000
MRC:
Indicates the location of the rectifier for the item.BCGM
Rectifier Location:
Integral
MRC:
The means by which the item is grounded.BCGN
Grounding Method:
External
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the shaft drive end.BCGS
Shaft Drive End Style:
Splined shaft end
MRC:
The speed the armature can revolve and produce maximum current,expressed in revolutions per minute.BCND
Maximum Rated Armature Speed In Rpm:
4000
MRC:
The total electrical voltage.ELEC
Voltage In Volts:
28.0