부품 정보
Two 0.113 diameter holes on each flange
TXT
묘사:
Nonmetallic Channel
MRC:
The style designation indicating the configuration that most nearly corresponds to the cross-sectional shape of the item.AAGR
Cross Sectional Shape:
Open channel
MRC:
A numeric value that reflects the hardness of a nonmetallic item when used in conjunction with a hardness rating scale.AASF
Nonmetallic Hardness Rating:
50.0 shore durometer a
MRC:
The maximum load in tension applied in a longitudinal direction,per unit of cross-sectional area,that the material can withstand without rupture.AASH
Min. Tensile Strength (psi):
1500 pounds per square inch
MRC:
A value which expresses the degree of heat or cold as applied to the operation,or limitation of operation,of an item.ABJH
Tempurature Rating:
-67.0 degrees fahrenheit
MRC:
The distance measured in a straight line from the bottom to the top of an item.ABKW
Overall Height:
Between 0.500 inches and 0.620 inches
MRC:
An overall measurement taken at right angles to the length of an item,in distinction from thickness.ABMK
Overall Width:
Between 0.360 inches and 0.390 inches
MRC:
A measurement of the longest dimension of any object,in distinction from width.ABRY
Length:
Between 1.500 inches and 1.620 inches
Right Side Flange Height:
Between 0.387 inches and 0.483 inches
Left Side Flange Thickness:
Between 0.110 inches and 0.140 inches
Right Side Flange Thickness:
Between 0.110 inches and 0.140 inches
Left Side Flange Top Outer Radius:
0.050 inches
Right Side Flange Top Outer Radius:
0.050 inches
MRC:
The environmental elements or conditions that an item is designed or protected to resist or withstand satisfactorily.ADZC
Environmental Protection:
Low temperature and high temperature
Fillet Radius Where Left Flange Joins Base Flange:
0.020 inches
Outer Radius Where Left Flange Joins Base Flange:
Between 0.105 inches and 0.135 inches
Base Flange Thickness:
Between 0.113 inches and 0.137 inches
Outer Radius Where Right Flange Joins Base Flange:
Between 0.105 inches and 0.135 inches
Fillet Radius Where Right Flange Joins Base Flange:
0.020 inches
MRC:
The style designation corresponding to the shape of the left-side flange tip.BHQU
Left-side Flange Tip Style:
Left w/inside and outside corner radii
MRC:
The style designation corresponding to the shape of the right-side flange tip.CZLZ
Right-side Flange Tip Style:
Right w/inside and outside corner radii
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Rubber
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Hms17-1527, type 3, class 50, hughes aircraft co mfr ref single material response
