TXT
묘사:
Quartz Crystal Unit
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
0.810 inches
MRC:
An overall measurement taken at right angles to the length of an item,in distinction from thickness.ABMK
Overall Width:
0.757 inches
MRC:
An overall measurement of the smallest dimension of an item,in distinction from length or width.ADUM
Overall Thickness:
0.350 inches
MRC:
The mode of frequency at which the device is designed to operate.AEHC
Mode Of Oscillation:
Fundamental
MRC:
The condition existing when the frequency or vibration equals the natural frequency.AEHD
Circuit Resonance:
Series resonance
MRC:
The total static capacitance of the item when measured across the terminals,expressed in picofarads.AEHF
Shunt Capacitance In Picofarads:
Between 0.575 and 0.565 and 0.585
MRC:
The permissible frequency deviation when operating at the reference temperature,expressed in percent.AEHK
Frequency Tolerance At Reference Tempurature In Percent:
-0.002/+0.002
MRC:
The temperature at the midpoint of the controlled operating temperature range.AEHM
Controlled Reference Temp:
25.0 degrees celsius
MRC:
The minimum and maximum limits of temperature at which the item is rated for operation.AFGA
Operating Tempurature Range:
-55.0/+100.0 degrees celsius
Center To Center Distance Between Terminals:
0.490 inches
MRC:
The permissible frequency deviation within the operating temperature range,expressed in percent.CRFX
Frequency Tolerance For Operating Tempurature In Percent:
-0.005/+0.005 and -0.0010/+0.0010
MRC:
The equivalent (effective) resistance for which the item is rated,expressed in ohms.CRMP
Equivalent Resistance Value In Ohms:
Between 5000.0 and 5300.0
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
97942-581r332h01 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
