MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the first end.AAGZ
First End Style:
Splined (involute)
MRC:
A term used to identify the ends as identical or not identical.AAHN
End Similarity:
Identical
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
Between 1.730 inches and 1.740 inches
MRC:
The length of a straight line which passes through the center of the first end,and terminates at the circumference.AMDL
First End Diameter:
Between 1.2610 inches and 1.2660 inches
MRC:
A measurement of the longest dimension of the first end spline,in distinction from width.AMDM
First End Spline Length:
Between 0.500 inches and 0.505 inches
MRC:
The length of a straight line which passes through the center of the smallest circular cross section of the first end spline,and terminates at the circumference.AMDN
First End Spline Minor Diameter:
Between 1.1100 inches and 1.1200 inches
MRC:
The length of a straight line which passes through the center of the largest circular cross section of the first end spline,and terminates at the circumference.AMDP
First End Spline Major Diameter:
Between 1.2610 inches and 1.2660 inches
First End Pressure Angle:
30.0000 degrees
MRC:
A measurement indicating the diameter-pitch per measurement scale of the first end.AMDS
First End Pitch Diameter:
1.2000 inches
MRC:
The number of steps provided.ATPC
Step Quantity:
3
First End Spline Quantity:
24
MRC:
The length of a straight line which passes through the center of the largest step,and terminates at the circumference.CSPY
Largest Step Diameter:
Between 1.377 inches and 1.378 inches
MRC:
Designates the specific surface roughness rating,representing the arithmetic average deviation of the surface from the meanline in profile.CSYM
Surface Finish:
32.0 microinches
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Ams6260 assn standard single material response
MRC:
The justification for the assignment of a federal supply class /fsc/ to an item based on the classification of the next higher classifiable assembly.ZZZV
Fsc Application Data:
Drive shaft, rotor, helicopter
