부품 정보
Shot peen per mil-s-13165 use s-170 size hard shot (rc 55-65) to an intensity of .012-.015a. 200 percent coverage required. 100 percent coverage to be determined by visual examination at 10 times magnification. Peening procedure must be approved by cwfs engineering. Dimensions apply before shot peening, plating and after heat treat. Do not shot peen on both ends to within.120-.150 of both ends. Item is cadmium plated or chromate treated
TXT
묘사:
Headless Grooved Pin
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the first end.AAGZ
First End Style:
Chamfered
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
Between 0.830 inches and 0.840 inches
MRC:
The length of a straight line which passes through the center of a circular figure or body,and terminates at the circumference.ABMZ
Diameter:
Between 0.2587 inches and 0.2591 inches
MRC:
A measurement of the longest effective dimension of an item.ABNZ
Effective Length:
Between 0.587 inches and 0.603 inches
Undercut Diameter:
Between 0.2285 inches and 0.2315 inches
Undercut Width:
Between 0.031 inches and 0.034 inches
Second Undercut Width:
Between 0.031 inches and 0.034 inches
First End Taper Length:
Between 0.020 inches and 0.040 inches
MRC:
Indicates whether or not the second end is identical to the first end.CQBB
Second End Relationship With First End:
Identical
MRC:
Indicates the location of the first end.CRDY
First End Location:
Both ends
First End Taper Angle:
Between 42.5 degrees and 47.5 degrees
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel comp 4340
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Groove
