TXT
묘사:
Headless Grooved Pin
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the first end.AAGZ
First End Style:
Chamfered and countersunk
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the second end.AAHP
Second End Style:
Chamfered and countersunk
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
3.380 inches
MRC:
The length of a straight line which passes through the center of a circular figure or body,and terminates at the circumference.ABMZ
Diameter:
Between 0.7495 inches and 0.7500 inches
MRC:
A measurement of the longest effective dimension of an item.ABNZ
Effective Length:
2.415 inches
Undercut Diameter:
0.400 inches
Undercut Width:
0.125 inches
Undercut Radius:
0.125 inches
First End Taper Length:
0.125 inches
MRC:
A measurement of the longest taper dimension at the second end,in distinction from width.AMFM
Second End Taper Length:
0.715 inches
MRC:
Indicates whether or not the second end is identical to the first end.CQBB
Second End Relationship With First End:
Not identical
MRC:
The minimum load,applied perpendicularly to the longitudinal axis of an item,at which point the item will fracture when subjected to the standard shear test method.CQSX
Shear Strength:
220000 single pounds per square inch
Second End Countersink Angle:
100.0 degrees
MRC:
Indicates the location of the first end.CRDY
First End Location:
Both ends
First End Taper Angle:
30.0 degrees
First End Countersink Angle:
60.0 degrees
MRC:
Designates the specific surface roughness rating,representing the arithmetic average deviation of the surface from the meanline in profile.CSYM
Surface Finish:
8.0 microinches outside diameter
First End Countersink Diameter:
0.250 inches
Second End Taper Angle:
7.5 degrees
Second End Countersink Diameter:
0.363 inches
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel comp xm-13
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Groove
