TXT
묘사:
Engine Accessory Generator
MRC:
The direction of the mounting hole thread when viewed axially. a right-hand thread winds in a clockwise direction while a left-hand thread winds in a counterclockwise direction.ACJC
Mounting Hole Thread Direction:
Right-hand
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the mounting.ADER
Mounting Style:
Bracket mtd w/three mtg holes, top hole threaded
MRC:
An indication of whether or not an item is capable of operation while submerged.AHZV
Submersibility:
Nonsubmersible
MRC:
The direction of rotation of a rotating shaft as viewed from the drive end.AKCT
Shaft Rotation Direction:
Clockwise
MRC:
Indicates the type of ground polarity utilized.AXHX
Ground Polarity Type:
Negative
MRC:
The minimum speed the armature can revolve and maintain full current output,expressed in revolutions per minute.BCGD
Armature Minimum Speed In Rpm At Full Current Output:
2500
MRC:
The maximum amount of output current for which the item is rated,expressed in amperes.BCGF
Maximum Output Current Rating In Amps:
60.0
MRC:
The cut-in speed necessary to maintain a minimum current flow,expressed in revolutions per minute.BCGG
Minimum Current Cut-in Speed In Rpm:
750
MRC:
Indicates the location of the rectifier for the item.BCGM
Rectifier Location:
Integral
MRC:
The means by which the item is grounded.BCGN
Grounding Method:
Internal
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the shaft drive end.BCGS
Shaft Drive End Style:
Straight shaft end, threaded, w/keyway
Angular Deviation Of First Hole From Top Center In Deg:
0.0
Distance Between Inside Surfaces Of Hinge Bracket:
Between 3.940 inches and 4.060 inches
Bottom Mounting Hole Diameter:
Between 0.514 inches and 0.524 inches
MRC:
The speed the armature can revolve and produce maximum current,expressed in revolutions per minute.BCND
Maximum Rated Armature Speed In Rpm:
8000
MRC:
A designation distinguishing one group of thread diameter-pitch combinations from another by the number of threads per measurement scale for the specific diameter of a threaded mounting hole.CMLK
Mounting Hole Thread Series Designator:
Un
MRC:
The length of a straight line which passes through the center of a threaded mounting hole,and terminates at the circumference.CMLL
Mounting Hole Thread Diameter:
0.500 inches
MRC:
The number of mounting hole threads per linear inch measured on a line parallel to the thread axis.CMLM
Mounting Hole Thready Qty Per Inch (tpi):
16
MRC:
A numeric-alpha designator indicating the pitch diameter tolerance and an external or internal mounting hole thread.CMLN
Mounting Hole Thread Class:
2b
MRC:
The total electrical voltage.ELEC
Voltage In Volts:
14.0
