부품 정보
Upper & lower front & rear doors rfi shielded; center horizontal rfi divider; end panel on one side
TXT
묘사:
Electrical Equipment Rack
MRC:
An overall measurement between specified points of an item,in distinction from height.ABFY
Overall Depth:
42.000 inches
MRC:
The distance measured in a straight line from the bottom to the top of an item.ABKW
Overall Height:
85.000 inches
MRC:
An overall measurement taken at right angles to the length of an item,in distinction from thickness.ABMK
Overall Width:
29.000 inches
MRC:
Indicates the type of door furnished with the item.AERQ
Door Type:
Double back and double front
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
Formatter subsystem an/fsq-13 (v)
MRC:
Describes the capabilities,intended use,and/or purpose for which the item is provided.FTLD
Functional Description:
Provides mounting for components at formatter subsystem
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Open frame vertical front
MRC:
Characteristics or qualities of an item,not covered in any other requirement,which are considered essential information for one or more functions excluding nsn assignment.SUPP
Supplementary Features:
Tempest enclosure; vertical mounting fails for tape and disk drivemounting; floor mounted; designed for ground installation
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
98230-0n329367-7 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
