부품 정보
Cable assembly, digital, i/o
TXT
묘사:
Electrical Ribbon Cable Assembly
MRC:
A measurement of the cross section taken at right angles to the length,in distinction from thickness.ADWH
Cross-sectional Width:
2.660 inches
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
An/tsm-19 (v) 5 electronics shop, transportable
MRC:
The center to center distance between the terminal holes.AGTK
Center To Center Distance Between Terminal Holes:
0.100 inches
MRC:
Indicates the type of facility provided on the device for attaching to another item.AKRZ
Termination Type:
Connector plug both ends all conductors
MRC:
The number of electrical conductors included on the item.AMQN
Conductor Quantity:
50
MRC:
The fabricated form of the conductor.CXCW
Conductor Form:
Solid all conductors
MRC:
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.FEAT
Special Features:
Cable is to be wrapped with tedlar tape in 3 places for labeling. Label a is to be located 6.0 inches from p1 (plus / minus 1 inch) and is to be labeled p1-1 to jgd2-1 of a2a7. Label b is to be located 24.0 inches from p2 (plus / minus 1 inch) and is to be labeled 26916-087-019605-010. Label c is to be located 6.0 inches from p2 (plus / minus 1 inch) and is to be labeled p2-1 to j42-1. Cable identifications shall be marked as shown on table 1 of drawing 087-019605 cage code 26916. Mark using contrasting ink iaw mil-std-130.
